♨
Temperature
AV—°C
20SV —45
No incubator—
Offline
⚡ Waiting for live data
Warnings
0
V2.12.12.28-hardware-sync
—
◉
Humidity
AV—%
0SV —100
✣
—Sensor 2Backup Temp
● Not installed
LEFTNext turn in—
RIGHTTotal turns today0
EQUIPMENT STATUS / OUTPUTS
AUTOON
0.00s
OFF
2.00s
0%
HumidifierOFF
0%
Circulation FanOFF
0%
VentilationN/A
—
Exhaust FanN/A
—
PID Temperature ControlAUTO
- Mode
- AUTO
- Current Temp (AV)
- —
- Target Temp (SV)
- —
- PID Output
- —
- Heater State
- ● OFF
Tap/click to adjust PID
TimerLive PID • 2.00 s SSR window
ON
0.00s
OFF
2.00s
◉
Incubation Progress
No active cycle
0%
LIVE CHAMBER CLIMATE
Heat & Humidity Distribution
Heater OFF
Humidifier OFF
Fan OFF
Teal = humidity mist
Red/orange = heater vapor
Circulation reacts to fan state
Temperature Trend (°C)
Actual (AV) Target (SV)Humidity Trend (%)
Actual (AV) Target (SV)DEVICES
Incubators
REAL-TIME CONTROL
Control & System
Commands are normally received by the controller within about one second. Local safety rules always have priority.
Control Mode
AUTOAUTO keeps incubation logic under local controller control. MANUAL enables remote output commands while retaining safety lockouts.
Manual Outputs
Live Control Status
- Command polling target
- 1 second
- Live data target
- ≤ 2 seconds
- Current live age
- —
- Pending commands
- 0
ADVANCED CONTROL & SYSTEM
System tools
PID Temperature Control
AUTO- Mode
- AUTO
- Current Temp (AV)
- —
- Target Temp (SV)
- —
- PID Output
- —
Heater State ● OFF
TimerLive PID • 2.00 s SSR window
ON
0.00s
OFF
2.00s
Alerts / Warnings
Hardware & Connectivity
- Controller
- BroodIt Controller
- Wi-Fi Signal
- —
- Firmware Version
- —
- Last Sync
- —
Legend
- ON / Active
- OFF / Inactive
- Warning
- Auto Mode
☷
Setpoints / Quick Adjust
Target Temperature—
Target Humidity—
INCUBATION / HATCHING
Cycle & Hatch Manager
Plan the full incubation cycle, automatically enter lockdown, stop egg turning, and keep a history of completed batches.
HISTORY
Trends
Temperature — Last 24 Hours
Humidity — Last 24 Hours
SAFETY
Smart Alarm Center
Active alarms remain here until the measured condition recovers. Acknowledging confirms the alarm was seen; it does not clear the condition.
LIVE
NORMALActive Alarms
LOG
Not loadedAlarm History
Open Alarm Center to load recovered alarms.
DATA
Reports & Storage
BroodIt separates fast live-state updates from historical storage. Live state updates every ~2 seconds without creating a new database row every 2 seconds; historical telemetry remains at the configured archival interval.
≤ 2 sLive-state target
—24h chart points
90 daysRaw history retention
2 years5-minute summaries
INCUBATOR PROFILE